Garage, shop, and commercial epoxy flooring for Washington City — shot-blast prepped, finished with UV-stable polyaspartic, and backed by a 10-year workmanship warranty. We're five minutes away and in Washington Fields every week.
Washington City is growing faster than anywhere in the county, and most of that growth comes with a 2- or 3-car garage on a fresh slab. Here's what most new homeowners don't hear from their builder: new concrete is the ideal time to coat — once it's fully cured, a shot-blasted epoxy system locks onto clean concrete that's never seen oil, sealer, or tire residue. Coating it right the first time means never dealing with a failing floor later.
We install full flake garage systems, solid color epoxy, and commercial systems across Washington — from Washington Fields to Coral Canyon to Green Springs. Same shot-blast prep on every job, same 10-year written warranty, and no travel fee, because Washington is a five-minute drive from our shop.
Full flake broadcast systems with polyaspartic topcoats — the finish most Washington Fields homeowners are after. Standard 2-car garages typically $1,600–$4,000 installed.
Detached shops and oversized bays get the same commercial-grade system, scoped for equipment loads, trailer traffic, and washdowns.
Warehouses, showrooms, and retail floors along the Telegraph and Washington Parkway corridors. Phased installs available so your doors stay open.
Exterior-rated coating systems with grit additive for pool-adjacent patios and front entries that take direct sun.
New construction epoxy is our most common Washington job — coating fresh slabs before the garage fills up. We coordinate directly with builders and homeowners on timing after cure.
Established garages that have taken a decade of sun and tires. Shot blasting strips the wear and any old coatings in one pass, then the new system goes down right.
Golf-course neighborhoods where the garage is part of the house's finish level. Flake blends matched to your taste, edges cut clean, jobsite left spotless.
Newer builds off Telegraph with builder-grade slabs ready for a proper system. We check slab moisture and cure before anything gets scheduled.
Every other epoxy contractor serving Washington preps floors by grinding or acid etching. Those methods produce a shallow surface profile that works fine in mild climates — and fails in ours, where slab temperatures swing 100+ degrees across the year. Shot blasting produces the deep CSP 3–4 profile that commercial manufacturers specify, and we're the only applicator in Southern Utah running the equipment.
That's not a marketing line — it's the reason we can offer a 10-year workmanship warranty while most competitors offer one or two years, or none at all. Deeper bond, longer floor, warranty to match.
Free on-site estimates across Washington City. We check the slab, give you a written number, and back the work for 10 years.
jackson@nicholsconcretesealing.com · Based in St. George, Utah